top of page

The T&E Eco pumps are available in rubber (110ER) or steel (110ES) gears.  Designed for operators who are hauling clean-fluid, this pump is a good alternative for someone who is looking for the efficiency of a T&E but might only haul a couple loads a week.

**Recommended for short-term use, clean fluid only!

NOT INTENDED FOR INFIELD HAULING

NO WARRANTY ON ECO PUMPS

ECO Pump

Printable PDF
Pump Features:
• straight through T&E cast housing with 4” inlet & outlet
• Medium cast endplates
• 4” Steel weld flanges
• 6” helical-cut steel or straight cast rubber gears
• Requires a minimum 4” hose & fitting
 
NOT FOR INFIELD HAULING
Caution required when purchasing this option, please call and speak to one of our customer service reps prior to purchasing. 
4000 180° ECO Pump
Part Numbers:
110ER  4” T&E 180° eco pump with rubber gears
110E      4” T&E 180° eco pump with steel gears
Tested Flow Rates
Installation Dimensions 
Note: Pump pressure is maximum safe operating pressure, not the maximum pressure the pump will produce.
Horsepower Requirements:
• Hydraulic Motor 30-40hp - 109 Series recommended
• Electric Motor 15-20hp with 440 VFD

“Our mission is to Design & Manufacture pumps that consider the users, the industry and environment and to provide great service to our customers”

CONTACT US

Call: 844 577 3825
Email: admin@tepumps.com
Visit: 6566 Township Road 370

Consort, AB, Canada 

T0C1B0

Recommended Operating Procedures:
• Maximum Temp: 212°F (regular seals)
• Maximum RPM: 110E      750 RPM at the pump
                                         110ER   500 RPM at the pump
• Maximum Pressure: 125 PSI
bottom of page